I would suspect that the domain name and security type is tripping you up. In Kerio Connect Client, you can set the address that is displayed on your outgoing messages and the address that replies come to. If you get this far the Outgoing server settings should be pretty much already setup except for SMTP server (you may have to change it to match incoming), security type (should match incoming type) and port (I normally use 465 for encrypted outgoing mail). (Unable to connect.) If I disable WiFi (and I have a cell signal) it connects correctly. Use compression on: Mobile, WiFi, OtherĪt this point if I have WiFi enabled I get Setup could not finish, Cannot connect to server. Port: typically the default value for port should work (143 for None and 993 for encryption) Hopefully the version of Kerio is current, otherwise you may need TLS but I can only verify Kerio 7.1) Select the Kerio connect Mail Server deployment option based on your environment. Security type: select None if your web access is HTTP or SSL (always) if it is HTTPS (preferred). This article refers to the Barracuda Message Archiver firmware version 5.0 and higher, and the Kerio Connect Mail Server. IMAP server: this is the domain name from your web access (i.e. Username: as you entered to log in via web access (NOTE: for myself it isn't the default value of just the username but I have to enter the full email address but this value is the same that you use for web access) ![]() ![]() "What type of account is this?", select IMAP entered email address and password and then clicked manual setup It sounds like you are making progress and I think I know what the problem is but to keep everything smooth, here is what I have done:
0 Comments
Leave a Reply. |